Aiwa NSX-V2100 Manual De Instrucciones página 16

SPECIFICATIONS
Main unit CX-NV2100
FM tuner section
Tuning range
Antenna
AM tuner section
Tuning range
Antenna
Amplifier section
Power output
Total harmonic distortion
Inputs
outputs
Cassette deck section
Track format
Frequency response
Recording system
Heads
87.5 MHz to 108 MHz
Wire antenna
530 kHz
tO
1710 kHz
(10 kHz
step)
531 kHz to 1602 kHz (9 kHz step)
Loop antenna
15 W+15W(I kHz, THD 10%,6
ohms)
12 W + 12 W(5O Hz-20 kHz, THD
less than
1
Y.,
6 ohms)
0.3 % (5 W, 1 kHz, 6 ohms, DIN
AUDIO)
VIDEO/AUX: 400 mV
SPEAKERS: accept speakers of
6 ohms or
more
PHONES (stereo jack): accepts
headphones of 32 ohms or more
4 tracks, 2 channels stereo
50 Hz – 10000 HZ
AC bias
Deck 1: Recording/playback/
erase head x 1
Deck 2: Playback head x 1
Compact disc player section
Laser Semiconductor laser(1= 780
nm)
D-A converter 1
bit dual
Signal-to-noise ratio
90
dB (1 kHz, O dB)
Harmonic distortion
0.03 % (1 kHz, O
dB)
Wow and flutter Unmeasurable
General
Power requirements
120 VAC, 60 Hz
Power consumption
40 w
Dimensions of main unit 260 x 308x 341
mm
(W XHXD)
(10'/4x 12'/4x132ini).)
Weight of main unit 4.5 kg (9 Ibs 15 02)
Speaker system SX-NV2100
Cabinet type 2 way, bass reflex (magnetic
shielded type)
Speakers
Woofer:
120 mm (4 3/4 in.) cone type
Tweeter:
10
(13/32in.) mm CWLWTliC type
Impedance 6
ohms
Output sound pressure level 87 dB/W/m
Dimensions (W x H
x
D) 220 x 302 x 238 mm
(8
3/4x 1P X93/8it7.)
Weight 2.5 kg (5
Ibs 18
02)
Specifications and external appearance are subject to change without
notice.
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution. Do not use strong
solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths
with a head cleaning cassette or cotton swab moistened with
cleaning fluid or denatured alcohol. (These cleaning kits are
commercially available.)
When cleaning with a cotton swab, wipe the recording/playback
head, t [sure head (deck 1 only), capstans, and pinch
Pinch;oller
~r—————n
}
,
)Ilers.
After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the cleaned
parts are completely dry before inserting the tapes.
To demagnetize the heads
The heads may become magnetized after long-term use. This
may narrow the output range of recorded tapes and increase
noise. After 20 to 30 hours use, demagnetize the heads with any
commercially available demagnetizer.
Care of diets
When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
After playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
Care of tapes
Store tapes in their cases after use.
Do not leave tapes near magnets, motors, television sets, or
any source of magnetism. This will downgrade the sound quality
and cause noise.
Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight.
15
ENGLISH