Publicidad
1
\
3
u
n
n
BAND
VIDEO
TUNER
I
AUX
CD
I
b
4
REC
!?
m
BASIC RECORDING
Preparation
Wind up the tape to the point where recording will start.
Only normal (type I) tapes can be recorded.
1
2
3
4
Insert the tape to be recorded on into the deck.
Insert
the tape with the side to be recorded
first facing
out from the unit and the exposed
side down.
Press the TAPE/REV MODE button to select the
reverse mode.
To record on one side only, turn on 1,
To record on both sides, turn on 3
or (3.
Press one of the function
buttons and prepare
the source to be recorded.
To recordfrom a
CD, press the CD button and load the disc.
To record from a radio broadcast,
press the TUNER
button
and tune in to a station.
To record
from the connected
source,
press the AUX/
VIDEO
button and play.
Press the
REC button to start recording.
When the selected
function
is CD, playback
and r;cording
start simultaneously.
When using the remote control, first press the.
REC button
and then press the <b
button within 2 seconds.
Il?l will be displayed
during recording.
To stop recording,
press the
button.
To pause recording,
press the II button. (Applicable when the
source is TUNER
or AUX/VIDEO.)
To resume recording, press
again.
To reduce
the noise
interference
of an MW/LW
broadcast
(for K model)
Press the BAND button while pressing
the SHIFT button on the
remote control to reduce the noise interference
when recording
an MW/LW
broadcast.
Each time the buttons
are pressed,
the
dot light @ is turned on and off in the display window.
+
m
Recording
cannot be done when the TAPE button is selected.
30
Publicidad
