Descargar Imprimir esta página

Aiwa Z-R554 Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press TIMER to display 0,
then press ENTER
within 6 seconds.
@
is displayed and the hour flashes.
'Q
I
If you press ENTER after 6 seconds, another operation may
start.
Designate the hour of the timer-on time by turning
MULTI JOG, then press ENTER.
Repeat to designate the minute of the timer-on
time.
After you designate the timer-on time, one of the source names
flashes on the display. '
Press one of the function
buttons to select a
source, then press ENTER.
If TUNER/BAND is pressed, the band cannot be selected in
this step.
Select the duration for the timer-activated
period
with MULTI JOG, then press ENTER.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5
6
7
Prepare the source.
To listen to a
CD, load the disc to be played first on tray 1.
To listen to a ta~e, insert the tape into Deck 1 or 2.
To listen to the radio, tune in to a station.
Press POWER to turn the unit off after adjusting
the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
m
)'
Get ready for the TAPE function
or the timer
recording.
To listen to the tape, press F.
To record the source, press .
on Deck 1.
When the timer-on time is reached, the unit turns on and
begins play with the selected
source.
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period,
on Deck 1 is released before the timer
is off.
When the tape length is longer than the timer recording period,
is not released. If
is not released for a long time, the tape
in the deck may be damaged. Press W=
to release
.
To check the specified time and
source
Press TIMER. The timer-on time, the selected source name and
the duration for the timer-activated
period are displayed for 4
seconds.
To cancel timer standby
mode temporarily
Press TIMER repeatedly until @ disappears on the display.
To restore the timer standby mode, press TIMER once or twice
to display ~.
Using
the
unit
while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
* 44
and W
are also available
instead
of MULTI JOG.
* IISET
is also available
instead
of ENTER.
~
15
ENGLISH

Publicidad

loading