Craftsman 917.28601 Manual Del Operador página 17

MAINTENANCE
BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE
SCHEDULE
EACN 8 25 50 100 SEASON STORAGE
use HOURS .OURS .OURS .OURS
Check Brake Operation _
Check Tire Pressure _ _#
T Check Operator Presence & ROS System,,
A Check for Loose Fasteners _#_ _#'
C ChecWReplace Mower Blades q_#'3
T Lubrication Chart _ _4_
0 Check Battery, Level _4
R Clean Battery and Terminals _
Check Transaxle Cooling
Check Mower Levelness
Check V-Belts if
Check Engine Oil Level _
3hanqe Enqine Oil (with oil filter) 14_1,2
Change Engine Oil (without oil filter' q_#_'t,2
N_ Clean Air Filter _f'2
G Clean Air Screen _#4_
Inspect Muffler/Spark Arrester if
N Replace Oil Filter (If equipped)
_1,2
E Clean Engine Cooling Fins if 2
Replace Spark Plug _ _#"
=_eplace Air Filter Paper Cartridge _2
_ _lace Fuel Filter ..... _ __
1 - Change more often when operating under a heavy load or
in high ambient temperatures.
2 - Service more often when operating in dirty or dusty conditions.
3 - Replace blades more often when mowing in sandy soil.
4 - Not required if equipped with maintenance-free battery.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover
items that have been subjected to operator
abuse or negligence. To receive full value
from the warranty, operator must maintain
tractor as instructed in this manual.
Some adjustments will need to be made pe-
riodically to properly maintain your tractor.
At least once a season, check to see if
you should make any of the adjustments
described in the Service and Adjustments
section of this manual.
, At least once a year you should replace
the spark plug, clean or replace air filter,
and check blades and belts for wear. A
new spark plug and clean air filter assure
proper air-fuel mixture and help your en-
gine run better and last longer.
BEFORE EACH USE
1. Check engine oil level.
2. Check brake operation.
3. Check tire pressure.
4. Check operator presence and
ROS systems for proper operation.
5. Check for loose fasteners.
LUBRICATION CHART
@ S_ -- @ Spindle
Zerk S,,:" Zerk
@Front Wheel q @Front Wheel
Berating L,, Bearing Zerk
@Engine
)Gearshift
_ _,,- - Pivots
d)SAE 30 or 10w30 Motor Oil
@General Purpose Grease
(_Refer to Maintenance "ENGINE" Section
iMPORTANT," Do not oil or grease the pivot
points which have special nylon bearings.
Viscous lubricants will attract dust and dirt
that will shorten the life of the self-lubricating
bearings. If you feel they must be lubricated,
use only a dry, powdered graphite type lu-
bricant sparingly.
17