Publicidad
Idiomas disponibles
Idiomas disponibles
Seat
Seat
Bolt
4.
Push down
on seat to engage
shoulder
bolt in slot and pull seat towards
rear of
tractor.
5.
Pivotseat
and panforward
and assemble
adjustment
knob and flat washer
loosely.
Do not tighten.
6.
Lower
seat
into operating
position
and
sit in seat.
7.
Slide
seat
until
a comfortable
position
is reached
which
allows
you
to press
clutch/brake
pedal all the way down.
8.
Get off seat without
moving
its adjusted
position.
9.
Raise seat and tighten
adjustment
knob
securely.
Flat Washer
Adjl
Knob
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE: If this battery is put into service after
month and year indicated
on label (label
located between terminals)
charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY"
in Maintenance
section of this
manual for charging instructions).
Seat
Label
Terminal
NOTE:
You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor from
the skid.
_:_ WARNING:
Before
starting,
read,
understand
and follow
all instructions
in the Operation
section
of this manual.
Be sure
tractor
is in a well-ventilated
area. Be sure the area in
front of trac-
tor is clear of other people
and objects.
TO ROLL
TRACTOR
OFF SKID
(See
Operation
section
for
location
and
function
of controls)
1. Press lift lever plunger and raise attach-
ment lift lever to its highest position.
2. Release
parking
brake by depressing
clutch/brake
pedal.
3. Place gearshift
lever in neutral (N) po-
sition.
4. Roll tractor forward off skid.
5. Remove
banding
holding the deflector
shield up against tractor.
TO DRIVE
TRACTOR
OFF SKID
(See
Operation
section
for
location
and
function
of controls)
1. Be sure all the above assembly
steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasoline.
3. Sit on seat in operating position, depress
clutch/brake
pedal and set the parking
brake.
4. Place gear shift lever in neutral (N) posi-
tion.
5. Press lift lever plunger and raise attach-
ment lift lever to its highest position.
6. Remove key from bag and start the en-
gine (see "TO START ENGINE"
in the
Operation section of this manual). After
engine has started, move throttle control
to idle (slow) position.
7. Depress
clutch/brake
pedal
into full
"BRAKE" position and hold. Move gear-
shift lever to 1st gear.
8. Slowly release clutch/brake
pedal and
slowly drive tractor off skid.
9. Apply brake to stop tractor, set parking
brake and place gearshift lever in neutral
position.
10.Turn ignition key to "STOP" position.
Continue with the instructions
that follow.
9
Publicidad
