Hilti NURON SIW 10-22 Manual De Instrucciones Original página 11

3.4.2 Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three
seconds. The system does not detect a potential malfunction of the battery due to misuse, for example
battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
4 Technical data
Rated voltage
Weight without battery
Speed settings
Rated speed under no load
Impact speed
Tool holder
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
*2356083*
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
2356083
SIW 10­22
21.6 V
2.86 kg
(6.31 lb)
2 settings
Mode I 0 /min ... 1,000 /min
(0 Hz ... 16.7 Hz)
Mode II 0 /min ... 1,250 /min
(0 Hz ... 20.8 Hz)
Mode I 0 /min ... 2,000 /min
(0 Hz ... 33.3 Hz)
Mode II 0 /min ... 2,500 /min
(0 Hz ... 41.7 Hz)
³⁄₄" square drive with
through hole and locking
ring
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
21.6 V
See the end of these operating
instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
English 7