Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
check the product using this section. In most cases the problem can be solved quickly.
PROBLEM
Product does not
start
Product does not
reach full power
Unsatisfactory
result
WWW.SENIXTOOLS.COM
POSSIBLE CAUSE
Direction selector at center locking
position
Battery pack not properly attached
Battery pack discharged
Battery pack capacity too low
Battery pack reaches its life cycle
Incorrect torque setting
Drill/screwdriver bit is dull/damaged
Drill/screwdriver bit is not suitable for
intended operation
SOLUTION
Switch the direction selector to
proper side
Attach properly
Charge the battery pack
Charge the battery pack
Replace with new battery pack
Adjust to a proper torque setting
Replace with new one
Use proper drill/screwdriver bit.
15 - EN
Publicidad
