Getac F110 Guia Del Usuario página 3

Identifying Components
No. Component
Release latch
Holding clamp
Docking connector
DC-In LED
Battery pack slot
VGA port
USB 3.0 port
USB 2.0 port
RJ45 port
Power connector
Installation
1. Push the release latch toward the right. The
holding clamp will slide up slowly.
2. Place F110 on the dock. Press down the
holding clamp until it clicks into place.
3. Connect the AC adapter as shown below.
The DC-In LED lights up, indicating power is
connected.
Charging Battery Packs
Align the battery pack's connector with the
battery bay's connector and insert the battery
pack into the bay.
CAUTION: While inserting the battery pack, keep
the ribbon strip in a flipped up position. If left
unattended, a squeezed strip inside the battery
slot can result in poor battery connector contact.
Flip up the
ribbon strip.
1