Sicam SBM 60 Manual Original página 54

en 54 | SBM V85 A | Maintenance
12. Maintenance
12.1 Cleaning and servicing
!
Before cleaning and servicing, switch off
SBM V85 A and disconnect mains plug.
!
Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure proper
operation and high performance of the SBM V85 A:
Servicing
Clean moving mechanical parts, treat with spray oil
or kerosene and lubricate with engine oil or a suitable
grease.
12.2 Spare and wearing parts
The manufacturer cannot accept any liability for
damage arising from the use of non-genuine
replacement parts.
Designation
Standard centering flange
Centering cone 42 - 65 mm
Centering cone 54 - 80 mm
Centering cone 75 - 110 mm
Weight pliers
Manual vernier caliper
Test clip
Calibration weight
Calibration weight (calibrated)
Voltage sticker V 230
Voltage sticker V 110
Direction of wheel rotation sticker
Tab. 2: Spare and wearing parts
|
1 695 600 571 2016-08-23
12.3
i
As part of service and upkeep (every six months), on
flange replacement or in the event of measurement
inaccuracies, it is advisable to calibrate the
SBM V85 A in the following sequence:
1. Flange calibration.
2. Calibrate the electronic vernier caliper.
3. SBM V85 A calibration.
4. Perform reference measurement.
12.3.1
1. Call up the "Settings and service" menu.
x
2. Enter the password: <r> <r> <o>.
"
The calibration menu is displayed.
Calibration with "Go" wheel
Flange calibration
Order number
1 695 602 400
Return to main page.
1 695 632 500
1 695 652 862
Electronic vernier caliper and Angular width gauge
1 695 605 600
calibration
1 695 606 500
1 695 629 400
1 695 602 700
12.3.2
1 695 654 377
1 695 654 376
i
Follow the instructions shown on the monitor.
1 695 101 269
1 695 100 854
1. Fit the flange (refer to Section 5).
1 695 653 878
i
Do not clamp the wheel, do not use any clamping
tools.
2. Select flange calibration and confirm with < I >.
 Calibration is started.
3. Close the wheel guard.
 Measurement commences.
"
Flange calibration completed.
"
Unbalance set to "0".
Calibration
Call-up of calibration menu
Flange calibration
SICAM srl soc. Unip