Jata JBCP3315 Instrucciones De Uso página 16

- It is important to discharge the battery before it is recharged, leave it on until it stops or
the power decreases clearly.
- The battery must be recharged every 6 months if it has not been used for said period
of time.
• Also recharge if it has not been used for more than a month.
• Slide the on/off switch (3) to start operation.
• The screen (4) will show a countdown, which starts at 99 and ends at 00, it indicates the
percentage of charge left in the battery, it does not correspond to minutes.
LUBRICATION
• For the hair clippers to work correctly it is absolutely necessary to lubricate the blades with
oil before each use.
• Carefully pour a few drops of lubricating oil (8), which is provided, between the teeth of the
blade, or if you have run out, with another high quality, acid free oil.
• Turn the hair clippers on for a few seconds and clean the excess oil off with a cloth.
CUTTING GUIDE
• The shaver have 3 cutting guides (1) (1-2-3 mm) which allow to be accurately put into different
positions.
• Place the guide in the blade and press it to leave it correctly fixed.
TRIMING BEARD
• Always remember you must begin with the cutting guide set to the longest cutting position
before setting it in the lower position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements
upwards and outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later you may use the shorter cutting guides.
THE FINAL TOUCHES
• Do not use the guide for the final touches.
• To get an exact and straight cut of the sideburns, neck, moustache and beard and the area
around the ears, turn the hair clippers round and place them at a straight angle with your
head so the blade is in slight contact with the skin, and shave downwards. This way you will
get a perfect finishing.
16