Publicidad
Idiomas disponibles
Idiomas disponibles
• The cleaning and maintenance done by users, can not be done by
children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
WALL ASSEMBLING
• attention: the minimum distances for wall mounting:
- From the floor: 25 cm.
- From the lateral walls: 10 cm.
• Warning: all objects (table, shelf, etc) must be over the appliance.
• To fix the appliance to the wall in follow the instructions as indicated in Figure 1.
• Note that the wing nut without screw must be placed in the lower anchorage.
INSTRUCTIONS OF USE
• Connect the appliance to the mains and press the power switch (1).
SELECTING THE OPERATING TEMPERATURE
• press the button
• press the
button repeatedly to set the desired temperature. The leDs of the display will indicate the selected
temperature, as shown in the following figure (Figure 2):
USE TIMER
• This mode has two ways of programming: on / off and off / on.
ON / OFF
• With this mode you can program the operation for a certain period, after which the device will disconnect.
• once the desired temperature is set, you can program the operating time by pressing the
controller (2) repeatedly.
• The leDs will light indicating the operating time. Note that the total time is the result of the sum of the hours
indicating the leDs that are on.
• example (Fig 3): The device is set to 21 degrees for 5 hours.
• To deactivate the timer function repeatedly press the
OFF / ON
• With this mode you can program the beginning of the operation, previously setting a certain time, after which
the device will be connected.
• For this option, first you must set the temperature at which you want the device to work by pressing the
button repeatedly.
• Then press the button
• select the time you want the appliance to be in the off position by pressing the
• The leDs will light indicating the time selected for starting the operation. Note that the total time is the result of
the sum of the hours indicating the lit leDs.
• example (Fig 4): The device will turn on after 5 hours.
• To deactivate the timer function repeatedly press the
REPLAY MODE
• With this mode you can program cycles on / off, which will be repeated.
• select the desired operating temperature by pressing the button
01 manual jata DK1000P-2000P.indd 16
of the programmer (2) to turn on the appliance. The "eco" led of the viewfinder will light up.
for 2 seconds. You will see how the temperature leds go out.
button until the hours' leDs go off.
button until the hours' leDs turn off.
as noted above.
16
button on the
button repeatedly.
14/07/16 16:25
Publicidad
