Publicidad
Idiomas disponibles
Idiomas disponibles
• Then repeatedly pressing the
• To activate the "Replay" function hold the
cycles.
• Immediately the hours' leds start flashing, stop pressing the
will switch to oN-eCo mode.
• To disable the "replay" mode press once on the
ON / ECO MODE
• With this mode you can program cycles on / eco, which will be repeated.
• select the desired operating temperature by pressing the button
• Then repeatedly pressing the
temperature and then in position eCo (18 °C).
• To activate the function oN / eCo hold the
the start of the cycles.
• To disable this mode, press once the
ANTIFREEZE FUNCTION
• With this feature you can set the device to be connected when the temperature in the room drops below 7
degrees C.
• To activate this mode, the switch must be oN (1) and temperature leDs off.
• To do so, repeatedly press the
BLOCKING OF THE DEVICE
• To prevent manipulation of the controls you can activate the lock by pressing simultaneously the buttons
and
.
• after 10 minminutes from the activation of blocking, the leDs will turn off.
• To unlock the device, proceed the same way.
TO TURN OFF
• When not using the heater, turn off the switch (1) and disconnect the device from the mains.
PAINTING THE "C" MODEL
• If you have purchased the model DK1000C or DK2000C, you can paint it the color you want.
• To do this, first, apply a coat of primer to ensure the paint adherence.
• paint device with at least 70 ºC resistant paint.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, ensure the appliance is unplugged from the mains.
• leave cool down the warm parts and clean with a soft dry cloth.
• Keep clean the air entrance and output grid.
• Never use chemical or abrasives, metal scourers, which may deteriorate the surfaces of the appliance.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. so you will help to the improvement of the environment.
01 manual jata DK1000P-2000P.indd 17
button to select the time for which the unit will remain on and then off.
button until the hours' leDs flash, indicating the beginning of the
button.
button you'll select the time for which the device will stay on at the selected
button until the hours and the temperature leDs flash, indicating
button.
button until the temperature's leDs turn off.
17
button, because if you leave it down longer, it
as indicated above.
14/07/16 16:25
Publicidad
