Jata JEVI1470 Instrucciones De Uso página 12

INSTRUCTIONS OF USE
• Place the appliance on a flat and heat resistance surface.
• Put the bowl in the centre of the desired plate (1300 or 1500 w).
• Connect it to the network.
INDUCTION COOK MODE
• The device will go into "standby mode", that is, the power LED light will remain blinking and "C" will appear
on the screens.
• Press the on-off switch (2) to turn on the device, the power LED light will remain fixed and the displays (5)
will show "ON". If the device is not handled in a few seconds, it will return to "standby mode".
• Turn the power selector (7) to the desired heating level. It has 7 power levels. P1-P7 on the 1500W board
and 6 power levels, P1-P6 on the 1300W board. By default, a starting power level is preset. P6 on the
1500W plate and P5 on the 1300W plate.
GRILL MODE
• The device will go into "standby mode", that is, the power LED light will remain blinking and "C" will appear
on the screens.
• Press the on-off switch (2) to turn on the device, the power LED light will remain fixed and the displays (5)
will show "ON". If the device is not handled in a few seconds, it will return to "standby mode".
• Fit the grill plate (4) on top of the plates (1).
• Press the Grill/Block button (3), the displays will show C4 by default.
• Turn any power selector (7) to adjust the desired one. This mode has 6 power levels (C1-C6).
FOR BOTH FUNCTIONS
• To adjust the operating time, press the timer (6) ,the screen will start to flash, by default it appears 30
minutes. Adjust the time with the power selectors (7) from 1 to 99 minutes when it flashes. Once the time is
set, it will be fixed in a few seconds and the screen will stop flashing. If you want to change the time after it
has been set, press the timer (6) again so that it flashes and you can change it.
• To lock the buttons and prevent them from being accidentally activated, press the lock button (3) for a few
seconds, the display will show "L". To unlock, keep the lock button (3) pressed for a few seconds until you
hear a sound and "L" disappears from the display.
• To turn off the device, press the on-off switch (2) and it will remain in standby mode and disconnect it from
the mains.
• If an error code appears on the display, refer to the table A
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, unplug the appliance from the mains and wait until the plate is totally cold.
• You can clean the body with a slightly dampened cloth.
• To clean the plate it is enough to use a slightly dampened cloth with soap. You also can clean the plate with
special products to clean vitro ceramic plates.
• If there are some hard residues you can use a scraper suitable for vitro ceramic hobs.
• Do not use abrasive or chemical products, metallic scourers, and such may deteriorate the surfaces.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
12