Publicidad
Idiomas disponibles
Idiomas disponibles
4
Press the TIMER button, the minute indicator will
blink. Set the minute with the
5
Press theTIMER button, the selected time is set.
Note: The input time to set each step must not take
longer than 15 seconds or it will return to time display.
Set the sleep timer
Use the sleep timer to turn the system off after a cer-
tain number of minutes when in play mode. By setting
the sleep timer, you can fall asleep to music and know
that your system will turn off by itself rather than play
all night. Press the SLEEP/TIMER button
edly, select a set period of time (in minutes). The unit
turns off automatically after the set period of time.
To confirm the sleep time
When the SLEEP button is pressed once, the
remaining sleep time is displayed. Wait for a
second until the display returns to the original
display.
To cancel the sleep timer setting
Repeatedly press the SLEEP button until the "00"
is displayed. Turning off the system also cancels
the sleep timer.
Troubleshooting
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following before requesting
service.
No power
-
Ensure that the AC cord of the apparatus is
connected properly.
-
Ensure that there is power at the AC outlet.
-
Press the standby button to turn the unit on.
No disc detected
-
Check if the disc is inserted upside down.
-
Wait until moisture condensation at the lens has
cleared.
-
Replace or clean the disc.
-
Use a finalized CD or a correctly formatted disc.
Remote control does not work
-
Before you press any function button, first select
the correct source.
-
Reduce the distance between the remote control
and the unit.
-
Insert the battery with its polarities (+/-) aligned as
indicated.
-
Replace the battery.
-
Aim the remote control directly at the sensor on
the front of the unit.
28
button or
button.
repeat-
Disc does not play
-
Insert a readable disc and ensure that the label
side faces up.
-
Check the disc type, color system and regional code.
Check for any scratches or smudges on the disc.
-
Press SETUP to exit the system setup menu.
-
Check if moisture has condensed inside the
system. If it has then remove the disc and leave
the system turned on for about an hour.
Disconnect and reconnect the AC power plug and
then turn the system on again.
Poor radio reception
-
Increase the distance between the unit and your
TV or VCR.
-
Fully extend the FM antenna.
-
Connect an outdoor FM antenna instead.
Audio or subtitle languages cannot be set
-
The disc is not recorded with sound or subtitles in
multiple languages.
-
The audio or subtitle language setting is prohibited
on the disc.
Cannot display some files in USB device
-
The number of folders or files in the USB device
has exceeded a certain limit. This phenomenon is
not a malfunction.
-
The formats of these files are not supported.
USB device not supported
-
The USB device is incompatible with the unit.
Try another one.
Timer does not work
-
Set the clock correctly.
-
Switch on the timer.
Clock/timer setting erased
-
Power has been interrupted or the power cord has
been disconnected.
-
Reset the clock/timer.
Unit does not work
-
This unit contains a microcomputer for signal
processing and control functions. In very rare
situations, severe interference, noise from an
external source, or static electricity may cause it
to lock. In the unlikely event that this should
happen, unplug the power cord from the wall outlet,
wait at least 5 seconds and then plug it back in
again.
Weak incoming call signal on iPhone
-
When playing music on the iPhone though the
docking station, the reception mode may be poor,
resulting in the iPhone not receiving a strong enough
incoming call signal.
DVD Microsystem
Publicidad
