Giropes XBAT Manual De Usuario página 14

3. REFILL CONSUMABLE PAPER FROM PRINTER
When changing the paper of the pallet truck printer, the following steps must be carried out, first we must identify the side of the
printable paper, because it is a thermal paper, it is only printable on one side of the paper.This part that we have identified as the printable side
must be in contact with the printheads of the printer.
1
To identify the side of the printable paper, simply make a mark on the paper
with a pointed element, such as the cap of a biro. This will be marked with a
dark tone, with this result we identify the printable side.
2
This part that we have identified as the printable side must be in contact with the
printheads of the printer.
3
We press the central button on the printer and at the same time we stretch the upper part of the transparent
printer lid.
We remove the paper and replace it with the new one previously identifying the
printable area. The printhead area can be identified because it coincides with the
3
position of the printer's own LEDs.
Leave a margin of 2 cm of paper on the outside and then make an paper removal by pulling upwards to cut the
paper.
14
| USER'S MANUAL | EN