Publicidad
Idiomas disponibles
Idiomas disponibles
Lockwasher
Blade
adapter
Crankshaft
Ke_
keyway
Crank
bolt
_ling
Hardened
Blade adapter
washer
edge
GRASS CATCHER
(If so equipped)
• The grass catcher may be hosed with
water, but must be dry when used,
• Check your grass catcher often for
damage or deterioration. Through
normal use it will wear, If catcher
needs replacing, replace only with a
manufacturer
approved replacement
catcher. Give the lawn mower model
number when ordering.
DRIVE WHEELS
Check front drive wheels each time
before you mow to be sure they move
freely.
The wheels
not turning
freely
means
trash, grass cuttings,
etc. are in the drive
wheel area and must be cleaned
to free
drive wheels.
If necessary
to clean the drive wheels,
check
both front wheels.
1. Remove
hubcaps,
hairpin
cotters
and
washers.
2.
Remove
wheels
from wheel
adjusters.
3.
Remove
any trash or grass cuttings
from inside the dust cover,
pinion and/
or drive wheel
gear teeth.
4.
Put wheels
back in place.
NOTE:
If after cleaning,
the drive wheels
do not turn freely, contact
your nearest
authorized
service
center.
GEAR CASE
• To keep your drive system
working
properly,
the gear case and area
around
the drive should
be kept clean
and free of trash build-up.
Clean
under
the drive cover twice a season.
• The gear case is filled with lubricant
to
the proper level at the factory.
The only
time the lubricant
needs attention
is if
service
has been performed
on the
gear case.
• If lubricant
is required,
use only Texaco
Starplex
Premium
1 Grease,
Part No.
750369.
Do not substitute.
ENGINE
LUBRICATION
Use only high quality
detergent
oil rated
with API service
classification
SF-SJ.
Select the oil's SAE viscosity
grade
according
to your expected
operating
temperature.
SAEVISCOSITYGRADES
I
NOTE:
Although
multi-viscosity
oils
(5W30,
10W30
etc.) improve
starting
in
cold weather,
these
multi-viscosity
oils
will result in increased
oil consumption
when used above
32°F. Check
your
engine
oil level more frequently
to avoid
possible
engine
damage
from running
low on oil.
Change
the oil after every 25 hours of
operation
or at least once a year if the
lawn mower
is not used for 25 hours
in
one year.
Check the crankcase
oil level before
starting
the engine
and after each five (5)
hours of continuous
use. Tighten
oil plug
securely
each time you check
the oil
level.
TO CHANGE
ENGINE
OIL
NOTE:
Before
tipping
lawn mower to
drain oil, drain fuel tank by running
engine
until fuel tank is empty.
1.
Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact
with spark plug.
2.
Remove
engine
oil cap; lay aside
on a
clean
surface.
3. Tip lawn mower
on its side as shown
and drain oil into a suitable
container.
Rock lawn mower
back and forth to
remove
any oil trapped
inside of
engine.
4. Wipe
off any spilled
oil on lawn mower
and on side of engine.
5.
Fill engine
with oil.
(See "Add Oil" in
the Operacion
section
of this manual.)
6.
Reconnect
spark plug wire to spark
plug.
12
Publicidad
