Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING GUIDE
|
Before requesting service for this unit, check the table below for the possible cause of the
problem. Some simple checks or minor adjustment on your part may eliminate the
problem and restore proper operation. If you are in doubt about some of the check points,
or if the remedies indicated in the chart do not solve the problem; refer to the directory of
authorized servicenters (see the servicenter list included) to locate a convenient
servicenter, or consult your authorized Panasonic dealer for instructions.
Probable cause(s)
Suggested Remedy
Massage does not start,
j
The power cord is not plugged
Plug the power cord into an AC
in.
outlet (120V).
The power source switch is at
Slide the power switch to "on".
the "off" position.
All lamps on controller flash with
| If the massage heads are
Raise your back slightly and
beeping sounds and massage
forcibly locked, they will stop for
| push the start/reset button.
heads Stop.
safety.
Kneading massage cannot be
The massage heads must move
| Wait until the massage heads
changed immediately to a rolling | to the narrowest position for a
reach the narrowest position.
massage.
rolling massage.
Massage heads do not reach
Your shoulders are too high.
Shift your waist forward and
your shoulders.
recline the chair back. °
It seems like the massage heads | This is because an alternating
are at different heights.
tapping mechanism is used. It is
not a malfunction.
EN
Alternating tapping mechanism
Approx.
13/32 in. (1 cm)
at most
Approx.
13/32 in. (1 cm)
at most
When stopped, the misalignment
is approx. 1cm at most.
19
Publicidad
