Publicidad
Assembly Instruction
EN
1. First fix the light in a suitable position, and use a tape measure to
determine the position on the wall and drill holes. Drill holes
according to the size of the screws, and then tap the plastic parts
into the drilled holes (as shown in the figure).
2. Twist the self-tapping screw into the fixed plastic part, leave the
screw about 15MM outside the wall, and ensure that the screw is
fixed well enough to bear the weight of the mirror.
3. Hang the mirror on the fixed screw, and align the hook behind the
mirror with the screw.
4. Lock the belt to the frame on both sides of the main body,
straighten it to mark the appropriate height, fix the inner
aluminum part, then secure the outer aluminum part to it, and
finally hang the belt (as shown in the figure).
(Fix the LED mirror first, then straighten and fix the belt. The belt
is only for decoration and cannot be used for load-bearing).
5. Insert the plug cord directly into the socket, and the connecting
wire can be hidden behind the mirror (if there is a reserved
power wire on the wall, you can cut off the plug of the light wire
and connect the light wire to the reserved wire).
06
Front View
Belt
Mirror
Light source key
Defogging key
Back View
Inner aluminum part
Outer aluminum part
07
Publicidad
