Sleep Mode - branatech PAC17-12-412 Manual Del Usuario

MINUS BUTTON
The original set temperature is immediately displayed when pressed, and the temperature va-
lue flashes. Each time the buzzer sounds, the temperature is set to "minus one". After stopping
the operation, the temperature set value flashes 5S to confirm the set value and return to the
current temperature value. The digital display order when pressing the key is as follows:
32→31→30→29→28→27→26→25→24→23→22→21→20→19→18→17→16
After pressing the timer button to enter the timer setting status, each time the buzzer sounds,
set the timer "minus one": 24→23
TIMER BUTTON
Bidirectional timing: when machine running , press button ,set time of power off; When the
machine is standby, press button, set the boot time ; press button then press add or decrease
to add or decrease 1 hour; Timing adjustable range is 1~24 hours, set to 0, then cancel the
timing.

SLEEP MODE

The sleep button is only valid when set in cooling or heating mode.
Press this button, the machine enters sleep mode, and the indicator lights up.
1. In cooling mode, 1 hour after sleep ON, the set temperature is automatically increased by 1°
C, and then automatically increased by 1°C after 1 hour. After 2 hours of sleep, the set tem-
perature is no longer raised.
2. In the heating mode, 1 hour after sleep ON, the set temperature is automatically decreased
by 1°C, and then automatically decreased by 1°C after 1 hour. After 2 hours of sleep, the set
temperature is no longer reduced.
3. 12 hours after sleep ON, the machine automatically shuts down.
4. Fan output in sleep operation: In the cooling mode, the fan automatically switches to low
wind; in the the heating mode, the fan can be turned down under the condition that the
internal fan is on. In low speed wind, the speed of fan can't be adjustable. After exiting
sleep, the wind speed is changed according to user's needs.
Full indicator
When the system senses full water for 5 seconds , the whole machine stops working. After the
fan delays for 3 minutes to turns off and the When water tank is full, indicator light shows red
and the unit will bizz for ten times. You can press any button to stop. You must empty the wa-
ter tank and put it back to correct position.
19
... ... ... ...
→1→0→24→23 Cycling in this way.