Craftsman 917.377520 Manual Del Usuario página 5

NOTE: For shippingpurposes,the rear
wheelson your lawn mowerare not
adjustedto the same positionas the front
wheels. Beforeoperatingmoweradjust
allwheels to the same cuttingheight
position.
Operator presence control bar
Uppper handle_./,_ /_,,_
"J'S"Lift up// /.,_
Lift
up
/Y M°wing
/ position
Lower handle
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging or
discharging:
o Open rear door and remove mulcher plug.
Store mulcher plug in a safe place.
o You can now install catcher or optional
clipping deflector.
, To return to mulching operation, install
mulcher plug into discharge opening of
mower. Be sure all tabs are seated
properly.
Mulcher plug _
CAUTION: Do not run your lawn mower
without mulcher plug in place or approved
clipping deflector or grass catcher in
place. Never attempt to operate the lawn
mower with the rear door removed or
propped open.
TOASSEMBLE GRASS CATCHER
o Insert leg of tubularframe through front
opening of grass catcher and thread frame
into sewn hem of bag.
NOTE: Keep bag hem gathered on the
straight leg of the tubular frame.
° When frame comes out the other end of
sewn hem, immediately work the end of
frame down inside the bag as shown in
inset°
= Slide sewn hem evenly around the tubular
frame until both ends of frame are exposed
out of the front opening.
o Assemble lower frame to tubular frame as
shown. Be sure handle is outside of bag
and frames are fully seated as shown in
inset_
° Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes° If
bag gets wet, let it dry before using.
Sewn hem
Tubular frame
!
Sewn hem
Lower Trame
Flip lid
7/
Tubular frame
Lower frame handle
(Frames must be
fully seated)
\
Vinyl bindings
5
i
I