Publicidad
Idiomas disponibles
Idiomas disponibles
16
CHARGING THE BATTERY PACK
Battery packs are shipped in a low charge condition to prevent possible problems. Therefore, you
should charge them until the green LED on the front of the charger comes on.
If the charger does not charge the battery pack under normal circumstances, return both the
battery pack and charger to your nearest authorised service centre for electrical check.
TO CHARGE
•
Use battery pack only with the recommended charger.
•
Connect the charger to the power supply. Make sure the power supply is normal household
voltage, 100-240 volts, AC only, 50-60.Hz
•
Make sure the latch of the charger snap into place and the battery pack is secured in the
charger before beginning operation.
•
Slide the battery pack along the groove of the charger.
•
Press down on the battery pack to be sure contacts on the battery pack engage properly
with contacts in the charger.
•
Do not place the charger and battery pack in an area of extreme heat or cold. They will work
best at normal room temperature.
NOTE: The charger and battery pack should be placed in a location where
the temperature is more than 10°C but less than 35°C.
•
The battery pack will become slightly warm to the touch while charging. This is normal and
does not indicate a problem.
•
After charging is complete, the charger green LED will remain on until either the battery
pack has been removed from the charger or the charger has been removed from the power
supply.
•
When batteries become fully charged, unplug the charger from the power supply and
remove the battery pack.
•
To remove the battery pack from the charger, depress the latch of the charger.
CHARGING A HOT BATTERY PACK
If the battery pack is above normal temperature range, the charger red LED and green LED will
begin flashing.
When the battery pack cools down to approximately 50°C, the charger will automatically begin
fast charge mode.
Publicidad
