INSTALLATION
INSTRUCTIONS
15
Connecfing
fhe drain line
Secure the drain hose in place to prevent
moving
and leaking
:-@ NOTE ..........................................................................................................................................
_,
• The drain hose should
be properly
secured
Failure to
properly
secure the drain hose can result in flooding
and
malfunction
• Total height of the house end should not exceed 96
inches (2448 cm) from the bottom of the washer
• The drain must be installed inaccordance with any
applicablelocal codes and regulations.
• Make
sure thatthe water linesare net stretched,
pinched, crushed, or kinked.
....
J
Clip the end of the hose into the elbow
bracket.
- Connect
the elbow
bracket
within
4 inches
(10 cm) from
the end of the drain hose. If the drain hose is extended
more
than 4 inches
(10 cm) beyond
the end of the elbow
bracket,
mold or microorganisms
could spread to the
inside of the washer
NO more
than
4 inches
(10
cm)
racket
2
Insert the end of the drain hose into the standpipe
Elbow
Bracket
3
Use a tie strap to secure the drain hose in place.
Clip the end of the hose into the elbow
bracket.
- Connect
the elbow
bracket
within
4 inches
(10 cm) from
the end of the drain hose
If the drain hose is extended
more
than 4inches
(10 cm) beyond
the end of the elbow
bracket,
mold,
or microorganisms
could spread to the
inside of the washer.
NO more
than
4
inches
(10 cm)
racket
2
Hang the end of the drain hose over the side of the laundry
tub.
_
Elbow Bracket
3
Use a tie strap to secure the drain hose in place