afx light HYBRID-360LED-FC Manual De Uso página 8

• In the event of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
• The light source of this device is not replaceable. If it is defective, the entire unit must be discard-
ed.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
FEATURES
• 1x 360W white LED lamp
• 22/20 DMX channels USITT DMX-512
• ArtNet
• 1 rotating gobo wheel with 2 rotating glass gobos, 5 metal gobos + Open, with speed adjust-
ment, stream effect, dithering effect, left/right rotation and gobo indexing
• 1 static gobo wheel with 11 gobos + Open
• 1 colour wheel with 10 colours + Open
• Gobo overlay (gobo morphing)
• Frost filter
• Totem mode
• DMX, master-slave, sound activated or auto operation (8 built-in programs)
• Electric focus from 2.5 – 15m
• Linear motorized zoom with 3-48° beam angle
• Linear CMY + CTO
• 25x/sec shutter/strobe with speed control
• 0-100% linear LED dimmer
• 3-facet prism, 5-facet prism and frost filter with variable speed & direction
• Preset variable/random strobe and dimming pulse effect
• 2.8" TFT LCD touch display (320 x 240px) with 4 buttons
• Improved optics and flat beam field
• Variable direction rainbow effect with speed adjustment
• Fan cooling system with constant temperature readout and management function
• Powercon IN/OUT connectors
• 3-pin XLR IN/OUT connectors
• RJ45 IN/OUT connectors for ArtNet
• IP20 protection rating
• 2x ¼ turn fastening Omega clamps
• Safety attachment point
FUSE REPLACEMENT
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus-
tomer support for further instructions. Continuing to use the unit may cause serious damage.
EN 8
© COPYRIGHT LOTRONIC 2023