Publicidad
E08
Desktop tilts when
running
HOT
Power supply
temperature is too high,
or runs for more than 2
minutes in 18 minutes
E11
Motor 1 not connected
E12
Motor 1 current
sampling channel error
E13
Motor 1 phase loss,
there is phase wire
disconnection
E14
Motor 1 Hall error, or the
Hall wire is
disconnected
E15
Motor 1 internal short
circuit
44
Reinitialize it
Wait fot power supply
temperature to cool down, or
let the system rest for 18
minutes then run again
Check the connection wire
Replace the control board
Check whether the motor
phase wire connection is
abnormal
Check the hall signal, or
replace the connection wire
Replace the motor
E16
Motor 1 stall
E17
The running direction of
motor 1 is wrong
E18
Motor 1 load is too
large, overload
E40
A control box is
disconnected in series
E41
The serial signal is
wrong
E42
Memory error
E43
error on sensor enabling
desk to stop when
encountering resistance
Reinitialize it again
Replace the motor wire or
Hall wire
Reduce the load
Check the connection wire
Check the connection cable,
or replace the control box
Replace the control box
Replace the control box
45
Publicidad
