KMINA K30031 Manual De Usuario página 3

1. USE OF THE BUCKET CHAIR
Before use:
1. engage the locking brakes and remove the seat
opening cover.
2. Place the bucket without the cover, under the seat.
3. Push the bucket from behind until it locks in place.
After use:
1. Pull back to empty.
2. Replace the lid.
3. After emptying, clean as described in
(Cleaning and Care).
Seat opening
TECHNICAL SPECIFICATIONS
LENGTH WIDTH
40" 25"
MATERIALS
Frame: Aluminum; Sear, backrest, armrests, Tire: PU; Footrest, Magnetic wheel: Nylon + fiberglass; Bucket: PP.
Pre-use checks
■ Please check that all parts are connected, have been correctly tightened and that the brakes work.
■ Check that the seat is securely fastened.
■ You must not use the KMINA PRO wheelchair to transport several persons or loads. Observe the appropriate uses.
■ Make sure that all parts are secure and that moving parts function properly. IF you find signs of wear or damage to your chair, DO NOT USE
IT.
■ Do not exceed the maximum user weight: 265 lb.
During use
■ All wheels must be in contact with the ground at all times and on a flat, smooth surface. Use ramps to cross any obstacles.
■ The KMINA PRO chair is designed for use indoors, bathrooms and showers.
■ Be careful if arms are flapping as clothing or body parts may get caught in the armrests.
■ Do not stand up on the footrests to get in or out of the chair, or in a stationary position.
■ Do not allow infants, small children and persons who do not understand the operation to use this product by themselves.
■ The brakes must be in the locked position before the uses explained above, including in the stationary position. Please note that the risk of
tipping may increase in the case of weight shift when moving your body. If the locking brake is damaged or not usable, the wheelchair must not be used.
■ Any serious incident involving the product must be reported to the manufacturer and to the competent authority of the Member State in which
the user and patient are established.
CLEANING AND CARE
■ Clean and disinfect the shower chair and toilet or bucket after each use with running water and conventional disinfectants.
■ The frame parts and upholstery can be cleaned with a damp cloth. In the case of the wheels as well, including a plastic brush (do not use
wire brushes!).
WARRANTY INFORMATION
■ KMINA warrants this chair to be free from defects. The warranty will remain in effect for 3 years from the date of original consumer purchase.
The warranty does not extend to parts exposed to natural wear and tear that require periodic replacement, such as brakes, wheels or
upholstery. The warranty does not cover:
- Replacement parts supplied by anyone other than KMINA or the authorized dealer.
- Any failure of the unit during the warranty period that is not caused by a defect in material or workmanship, or if the failure is caused by
misuse.
- KMINA is not liable for accidental damage or property damage.
■ In case of return, properly pack the chair preferably in its original packaging, otherwise KMINA will not be responsible for possible damage
caused during shipping.
2. USE OF THE CHAIR WITH CONVENTIO-
NAL TOILET
Before use, check that the height of your toilet
is lower than the maximum height allowed (43
cm).
1. Pull out the bucket from the rear.
2. Remove the seat opening cover.
3. Lift the toilet lid.
4. Place the chair in the toilet opening and
engage the locking brakes.
Placing bucket
without lid
HEIGHT USER MAX. WEIGHT
37"
SEAT HEIGHT
WEIGHT
265 lb
SEAT MEASUREMENTS
21" 17.3"x16.5"
2
3. USING THE CHAIR IN THE
SHOWER
1. Engage the locking brakes.
2. Pull back and remove the
bucket.
3. Remove the seat opening
cover for cleanliness and hygiene.
IMPORTANT: Do not attach the
bucket while the user is still
seated in the shower chair.
Ø DRIVE WHEELS (x2)
37.5 lb
LENGTH WITHOUT LEGREST
24"
27.5"