Installation Instructions
C4]
MOUNT THE OVEN (continued)
CS}
INSTALLING THE CHARCOAL
_
FILTER
insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
Remove 2 screws on top of oven, just above
ere me have at east two facurns after |
the grille panel, using a Phillips screwdriver.
the threads
have engaged. (It will
be completely
Open the door.
tightened later.)
Remove the grille.
Cabinet Bottom Shelf
rs
Screws
Filler Block
Grille
!
Cabinet Front
ensure proper
Cabinet Recess | :
:
y installation
Vf
Self-Aligning Screw
Oven Top
Insert 3 self-aligning screws
Insert the filter into the oven as shown until it fits
(W'-28 x 2%") through outer
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
top cabinet holes. Turn two full
turns on each screw.
screw completely
(1/4" x 28 x 256")
|6| Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet)
Charcoal filter installed
Replace the grille and the 2 top screws.
iG
Close the door and replace left side screw.
Install grease filters. See the Owner's Manual
packed with the oven.
22