Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING AND MAINTENANCE MANUAL
SERIE HIPPO
El caudal disminuye
Low fl ow or insuffi cient
7. TRANSPORT
The machines in question shall be supplied in suitable packaging to ensure adequate protection
during all stages of transport.
If on receipt of the goods the packaging is damaged, it is necessary to ensure that the machine
has not been damaged during transport and that it has not been tampered with. In the event of
damage to the equipment or if any part of the machine is found to be missing, the transporter and
the manufacturer must be notifi ed immediately and the corresponding photographic documenta-
tion must be provided. Materials used to protect the equipment during transport must be disposed
of using the disposal channels existing in the country of destination.
8. LIFTING AND MOVING
For all lifting and moving operations, the operator must use the minimum personal protective equi-
pment required for the operations to be carried out (safety shoes, gloves and protective helmet).
Machines with a dead weight of more than 25 kg must be moved using suitable moving systems
with a capacity greater than the weight of the machine to be handled. (See the weight indicated
on the packaging). If it is necessary to use belts for handling the machine, these must be in good
condition and must be of adequate strength for the weight of the machine to be handled.
Pumps weighing <25 kg may be lifted manually by the operator without the aid of lifting gear.
9. STORAGE
The equipment must always be stored in a covered place, not excessively humid, protected from
atmospheric agents and with temperatures between -10 °C and +40 °C, avoiding direct exposure
to sunlight. If the machine is to be stored for long periods, it is advisable not to remove it from its
packaging.
www.proindecsa.com / proindecsa@proindecsa.com
Is the pump inlet clean?
Is the impeller clean?
The discharge pipe is not
partially clogged?
Are you sure that the pump
inlet is not obstructed?
Is the impeller clean?
Are you sure that the outlet
pipe is not obstructed?
Is the diameter of the dischar-
ge pipe enough?
11
Clean the area or areas in
question (s)
Clean the zone (s) concerned
and verify check valve, if
applicable
Connecting a pipe with a
suitable diameter and su-
ppress reduction of the water
passage
Publicidad
