Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
When using electric tools and
their accessories, always follow basic safety
precautions to reduce the risk of fire, electric shock
and personal injury, including the following:
BEFORE USING THIS ACCESSORY, READ
AND UNDERSTAND THE INSTRUCTION
MANUAL THAT CAME WITH THE VACUUM
• Do not allow the accessory to be used as a toy.
Pay close attention when the accessory is used
by or near children.
• Use this accessory ONLY as described in the
manual. Use only D
attachments.
• To reduce the risk of heal hazards from vapors or
dust, do not use dust separator with toxic materials.
Do not use or store near hazardous materials.
• To reduce the risk of injury from accidental starting,
always shut off vacuum and disconnect the power
plug from the wall outlet before connecting the
dust separator to the vacuum.
• Wood dust mixtures are highly ammable and can
be explosive.
• NEVER introduce sparks or sources of ignition
into collector.
• Do not use the accessory to pick up ammable or
combustible liquids, such as gasoline, or use in
areas where ammable or combustible liquids
are present.
WARNING:
This product can expose people
to chemicals including lead, which is known to the
State of California to cause cancer, birth defects or
other reproductive harm. For more information go to
www.P65Warnings.ca.gov
WALT recommended
E
THE DUST SEPARATOR IS MADE
OF STATIC DISSIPATING PLASTIC
HOW TO MAKE TEMPLATE FOR
DRUM LID AND DUST SEPARATOR
1. Place dust separator drawing in center
of drum lid.
2. With pen, trace around base and bolt
holes.
3. Connect opposite bolt holes with lines
as shown above to nd center.
4. As shown in the gure, the circle with
a center diameter of 3.09 "is the hole size
of the drum lid. Cut this area (the shadow
part in the center) on the drum lid.
5. Use 11/64"drill bit (the drill size should not
be greater than the recommended size) to
drill the bolt holes. The drilling locations are
the six shaded areas shown in the gure.
6. With the Lid in an upside down position,
insert provided screws, Use screwdriver
to secure and tighten.
7. Lid must completely seal to drum. Seal ring
must be used. Any air leaks will affect
performance.
8. Attach one hose from top dust separator
outlet to shop vacuum and the other hose
from side dust separator inlet to your tools
or use hose by itself to pick up waste.
2
ENGLISH
Publicidad
