Publicidad
Idiomas disponibles
Idiomas disponibles
Jandy
Infinite WaterColors
®
PCBA Replacement
To reduce the risk of electric shock, fire or injury, service should only be attempted
by a qualified pool service professional.
Risk of electric shock which can result in serious injury or death: Before attempting
to install or service, ensure that all power to the circuit supplying power to the
system is disconnected or turned off at the circuit breaker. All wiring must be done
in accordance with the National Electrical Code® (NEC)®, NFPA-70®, including
those in Article 680 - Swimming Pools, Fountains, and Similar Installations.
In Canada, the Canadian Electrical Code (CEC), CSA C22.1, must be followed. All
applicable local installation codes and regulations must be followed.
LED Light Controller is in acceptable working condition; including all seals/gaskets
must be in place and functional; grounding lug must be present, functional, and
bonded; and corrosion must not compromise ingress protection against weather.
Additionally, all hardware must be present and functional. If any of the
aforementioned conditions are not met, a new enclosure MUST be used.
1. Turn off power to the Light Controller at the breaker panel.
2.
Remove Light Controller lid screw.
3.
Pull lid up and remove from Light Controller.
4.
Unplug white transformer input wire connector harness, see
Figure 4 (1).
5.
Use a screwdriver to loosen output wire screws enough to
remove blue transformer output wires, see Figure 4 (2).
6.
Loosen 2 PCBA bracket mounting screws.
7.
Remove the two PCBA lower wire terminals, see Figure 4 (3)
8.
Move PCBA bracket up until slots clear the PCBA bracket
mounting screws, see Figure 4 (4).
9.
Unplug white lower PCBA connector, see Figure 4 (5).
LED Light Controller | Spare Parts Installation Manual
™
WARNING
Page 9
Publicidad
