TO REMOVE DUST BAG
WARNING
Pull out on the
bag cover release
located near the
top of the bag
cover.
Bag Cover
Release-_T
_
Bag
I/
Cover-_i_
Bag
Pull the bag
cover forward
and lift up.
Remove and lay
aside.
Grasp the dust bag
collar and pull gently,
carefully removing
the dust bag.
Throw away the used
dust bag.
Do not reuse.
J
"
"
Bust
Bag
- Bag Holder
Check the bag
holder and the
motor safety fil-
ter. If either is
blocked, check
Safety
TROUBLE-
Filter
SHOOTING.
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet freshen-
er, face powder, fine dust, plaster,
soot, etc. can clog the bag and cause
it to burstbefore it is full. Change bag
more often when vacuuming these
materials.
TO REPLACE DUST BAG
Unfold the new
dust bag.
Fold
the safety seal
tab on the new
dust bag away
from the open-
ing that fits on
the bag holder.
Dust
Bag
NOTE: See PARTS AND FEATURES for
bag number.
Insert the dust bag
onto the bag holder
completely
by hold-
ing the bag collar.
Place the dust bag
collar into position.
Tuck the bag
behind each of the
Bag
four bag retention
Retention
Corner
corner flaps shown
Flaps
here.
Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Slots
Position the bag
cover so its posi-
tioning tabs fit
into the body
positioning
tab
slots.
Close the bag
cover.
You will hear a
I1=
distinct snap
Bag
when cover is
Cover--_
securely closed.
Check to see that the dust bag is fully
enclosed in the bag cover.
15