Descargar Imprimir esta página

Avanti SED70D0W Manual De Instrucciones página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
The correct exhaust installation is YOUR RESPONSIBILITY.
Use a 4-inch (10.2cm) diameter rigid aluminum or rigid galvanized
steel duct.
Do not use smaller diameter than recommended diameter duct.
Ducts larger than 4 inches (10.2cm) in diameter can result in
increased accumulation of lint and changes in performance
Lint should be removed regularly from internal filter every cycle and
from ducts.
If a flexible metal duct must be used, use the type with a stiff sheet
metal wall. Do not use a flexible duct with a thin foil wall. A serious
blockage can result if the flexible metal duct is bent too sharply.
Never install any type of flexible duct in walls, ceilings, or other
concealed spaces.
Keep the exhaust duct as straight, short as possible, minimum elbows
Secure joints with aluminum tape. Do not use screws.
Plastic flexible ducts can kink, sag, be punctured, reduce airflow,
extend drying times, and affect the dryer operation.
Exhaust systems longer than recommended 90 ft can extend drying
times, affect machine operations, and collect lint.
The exhaust duct should end with an exhaust hood with a swing-out
damper to prevent back drafts and entry of wildlife. Never use an
exhaust hood with a magnetic damper.
The hood should have at least 12 inches (30.5cm) of clearance
between the bottom of the hood and the ground or other
obstruction. The hood opening should point down.
Never install a screen over the exhaust outlet.
To avoid lint buildup, do not exhaust the dryer directly into a window
well. Do not exhaust under a house or porch.
If the exhaust duct must run through an unheated area, the duct
should be insulated and slope slightly down towards the exhaust
hood to reduce condensation and lint buildup.
Inspect and clean the interior of the exhaust system at least once a
year. Unplug the power cord before cleaning.
Check frequently to make sure the exhaust hood damper opens and
closes freely.
Check once per month, and clean at least once per year. NOTE:
If your clothes are not getting dry, then check the ducting for
obstructions.
Do not exhaust the dryer into a wall, ceiling, crawl space, or
concealed space of a building, gas vent, or any other common duct
or chimney. This could create a fire hazard from the lint expelled by
the dryer.
Do not use non-metallic flexible duct.
To reduce the risk of fire, this dryer MUST BE EXHAUSTED
OUTDOORS.
13

Publicidad

loading

Este manual también es adecuado para:

Sgd70d0wg