Kohler K-T617 Guia De Instalacion página 5

Sleeve
Setscrew
Setscrew
3. Install the Spout
CAUTION: Risk of product damage. Use care when installing
the spout assembly to prevent damage to the O-ring seal.
IMPORTANT! Keep the spout supply tube clean above the finished
deck to avoid damage to the O-ring seal.
Loosen the setscrews in the sleeve.
Use a twisting motion to install the sleeve on the spout supply
tube until it contacts the deck or washer.
Align the sleeve with the setscrews offset from the center (not
facing directly forward or backward) of the supply tube.
Tighten the setscrews.
When supplied, position the ring over the sleeve so it rests on the
washer.
Apply a ring of plumbers putty or other sealant around the
underside of the decorative ring (if supplied) or spout (if there is
no decorative ring) according to the manufacturer's instructions.
When supplied, fit the decorative ring over the washer.
Position the spout on the sleeve, and carefully press down until
the spout contacts the finished deck.
Align the spout as desired, and tighten the setscrew.
Insert the plug button (if included) over the setscrew, flush with
the spout surface.
Kohler Co.
Spout
Plug
Button
Apply
Plumbers
Putty To
Setscrew
Decorative
Ring or Spout.
Decorative
Ring (When
Supplied)
5 1013201-2-B