Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Nominal supply voltage
Supply voltage range (min–max)
Max. output voltage (LED Vf)
Maximum current per single output
Maximum power per single output
Maximum total current
Total max. power 3ch (5A/ch)
Total max. power 4ch (4A/ch)
PWM frequency
Current control resolution
Operating temperature
Protections
Operating Modes
To activate the various operating modes, you must set the corresponding mode via the Contraves devices (2), while the Con-
traves device (6) sets the operating current independently.
The display (8) shows the status of the set mode and current as well as the detected temperature:
Current setting:
The current is set via the associated Contraves device (6) to one of the following preset values:
DALI (DT6) mode:
Use the three Contraves devices (2) to set a value between
DMX-RDM mode:
With the board switched off:
-
if you set a value between
-
if you set a value of 0 or a value between
first DMX channel by sending it via RDM command.
0–10V inputs:
You can select from 1 to 3 0–10V inputs by setting the following values:
600-601:
1 input (controls all the outputs);
602:
2 inputs (the first controls outputs 1 and 2; the second controls outputs 3 and 4);
from 603 to
609:
3 inputs (the first controls output 1; the second, output 2; the third, outputs 3 and 4).
1–9V inputs:
You can select from 1 to 3 inputs 1-9V by setting the following values:
610-611:
1 input (controls all the outputs);
612:
2 inputs (the first controls outputs 1 and 2; the second controls outputs 3 and 4);
from 613 to 619:
3 inputs (the first controls output 1; the second, output 2; the third, outputs 3 and 4).
22 kOhm potentiometer:
You can select from 1 to 3 potentiometers (22 kOhm) using the following values:
620-621:
1 potentiometer (controls all the outputs);
622:
2 potentiometers (the first controls outputs 1 and 2; the second controls outputs 3 and 4);
from 623 to 629:
3 potentiometers (the first controls output 1; the second, output 2; the third, outputs 3 and 4).
L&L Luce&Light srl / Via Trescalini, 5 / 36031 Dueville, Vicenza / Italy / T +39 0444 36 05 71 / F +39 0444 59 43 04
Main electrical characteristics
Actual
Mode (2)
1 and
512, using the three Contraves devices, the address of the first DMX channel will be the corresponding set value;
513 and
E lucelight@lucelight.it / www.lucelight.it
12 - 24 - 48 Vdc
10 ÷ 52 Vdc
Vin – 0.6V max (*)
5A
120W (@24V); 240W(@48V)
16A (4A x 4ch or 5A x 3ch)
360W (@24V); 720W (@48V)
384W (@24V); 768W (@48V)
2.9 kHz
14bit
0 ÷ 40 °C
Open circuit, short circuit, overtemperature
PALETTE 4
T.35C
900 and
999.
599, with the three Contraves devices, you can select the address of the
ARVUNID2-01
Actual
Temperature
3/8
Publicidad
