Publicidad
Idiomas disponibles
Idiomas disponibles
En ENGLISH
Designed for work with cutting disc and diamond cutting discs. Once the cutting guard clip is fitted, the
safety guard becomes a cutting guard.
B Extraction guard for cut-off grinding Designed for cutting through stone slabs with diamond cutting
discs. With nozzle for extracting stone dust using a suitable extraction unit.
C Extraction guard for surface grinding Intended for grinding of concrete, screed, wood and plastics
with diamond cup wheels and/or fibre discs and suitable sanding plates. With nozzle for extracting stone,
wood and plastic dust using a suitable extraction unit. Not suitable for extracting sparks or for grinding of
metals.
D Dust filter
The fine mesh filter prevents coarse particles from entering the motor housing. Remove regularly and clean.
E Hand protection
Intended for work with backing pads, sanding plates, wire brushes and support plates, sanding pads, wire
brushes and diamond Drill Bits for tiles.
Install hand guard under the additional side- mounted handle.
F Multiple position bar for side handle
Permits numerous handle positions.
For a complete range of accessories, see
11. Repairs
Repairs to electrical tools must be carried out by qualified electricians ONLY! If the connection lead is
damaged, it must be replaced by a special connection lead. Contact your local Walter representative
if you have Walter power tools requiring repairs. For addresses see
You can download a list of spare parts from www.walter.com.
12. Environmental Protection
The generated grinding dust may contain harmful substances. Dispose appropriately.
Observe national regulations on environmentally compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanatory notes on the specifications on page 4. Changes due to technological progress reserved.
Ø
= max. diameter of the accessory
t
= max. permitted thickness of the clamping shank on accessory when using 2-hole nut (13)
max,1
t
= max. permitted thickness of clamping shank on accessory when using "Quick-R" clamping nut
max,2
t
= roughing disc/cutting disc:
max,3
max. permitted thickness of accessory
M
= spindle thread
l
= length of the grinding spindle
n*
= no-load speed (maximum speed)
n
*
= no-load speed (adjustable)
V
P
= rated input power
1
P
= power output
2
I
= Current at 120 V
120 V
m
= weight without mains cable
* Machines with the designation DYNAMAX or DIALSPEED : Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations disappear, however, as soon as the interference fades away.
The technical specifications quoted are subject to tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the emissions from the power tool and to compare
different power tools. Depending on the operating conditions,
accessories, the actual load may be higher or lower.
www.walter.com
or the accessories catalogue.
www.walter.com.
the condition of the power tool or the
13
Publicidad
