Publicidad
Idiomas disponibles
Idiomas disponibles
Note: This universal mounting bracket assembly is designed to
work with other available attachments, such as a weight kit used in
conjunction with the snow blade or snow thrower attachment. Utilize
the contact information on the front or back cover of this manual, or
contact the store in which you purchased this equipment to find out
more about available attachments for your specific tractor.
2.
Flip over assembly and mount the hitch support bracket to the
mounting assembly using four 710-3008 hex bolts and 712-04063
flange lock nuts from hardware pack 689-00087. See Fig. 5 for
proper orientation.
Side View
Note: When attaching the hitch support, do not fully tighten the
bracket at this time. This will facilitate the mounting process in later
steps.
Assembling The Bin Support Assembly
Locate the upright support bracket and the bin support assembly.
Assemble it by following these steps:
1.
Lay the bin support assembly topside down with the mounting
bracket portion facing upwards.
2.
Insert the notched end of the vertical support bracket into the bin
support assembly, as in Fig. 6.
ASSEMBLY AnD InSTALLATIOn
Figure 5
Figure 6
3.
Secure with a carriage bolt (710-0276) and flange lock nut (712-
04063) packed in with the upright support bracket. See Fig. 7.
Mount Assembly on Tractor
Install the mounting assembly on the tractor as follows:
1.
Place the hooked ends of the bagger mounting assembly over
the shoulder bolts, as in Fig. 8, on the tractor and line up the
hitch support hole on the mounting assembly with the hole on the
tractor's hitch.
2.
Install the clevis pin (711-0309A) from hardware pack 689-00087
into the tractor's hitch and the assembly's hitch support and
secure with a hairpin clip (710-0117). See Fig. 9 on the following
page.
Note: Feed the clevis pin down through the hitch support and
secure it, using the hole closest to the head, underneath with the
hairpin clip. However, you may find it easier to feed the clevis pin
up through the hitch plate hole and secure with the hairpin clip on
the topside.
9
Figure 7
Figure 8
Publicidad
