neno Lucy Manual Del Usuario página 8

12. Do not use the product if you see cavities, cracks or damage.
13. Do not use accessories or spare parts other than those approved by the manufacturer.
14. Make sure the clamps are correctly attached to the bath tub before placing the baby in the insert.
15. Do not leave the product in direct sunlight or close to heat sources such as electric heaters, gas heaters, etc.
16. Do not allow the thermometer to flood completely.
17. When not in use, the tub should be stored out of the reach of children.
18. The water should be drained into a suitable drain (e.g. bath, toilet, sink) and only after the child has been removed from the
bath.
WARNING - DANGER OF DROWNING AND FALLING:
There have been cases of children drowning while bathing.
Drowning can occur in a very short time and in very shallow water (e.g. 2cm).
There have been reported cases of head injuries in children as a result of falling out of bath tubs.
02. CONTENTS OF THE KIT
1. Bathtub
2. Water drain plug
3. Electronic thermometer
4. Shelf with recesses for bath products
5. Adjustable bath liner
03. UNFOLDING THE BATHTUB
1. Place the tub on a flat surface in the upside down position.
2. Spread the legs on both sides. SEE FIG. A. 1.
3. Stand the tub on its feet, then push the bottom first on one side and then on the other. SEE FIG. A. 2.
4. Make sure the legs and the bottom of the tub are correctly unfolded before use. SEE FIG. A. 3.
5. Make sure the drain plug is tightly closed before filling the tub with water.
04. FOLDING A BATHTUB
1. Turn the tub upside down and press the bottom first on one side and then on the other. SEE FIG. B. 1.
2. Fold the leg inwards by simultaneously pressing the two self-folding clamps on both sides of the leg. Repeat for the other leg.
SEE FIG. B. 2.
NOTE: Make sure the product is dry before assembling and storing the tub.
05. ADJUSTABLE BATH LINER
SEE FIG. C.
1. Attach the clamps located at the ends of the five arms of the insert to the edge of the tub.
2. Adjust the length of the arms to the size of the tub and your needs by wrapping them inwards.
3. Make sure all arms are properly attached before placing your child in the insert.
06. TERMOMETER
1. To measure the water temperature before bathing, place the thermometer probe at the end of the cable in the water. The
temperature will appear on the display. SEE FIG. D.
2. The length of the cable can be adjusted using the knob below the display.
3. To replace the battery, pull out the shelf with recesses or bath products and open the lid located at the bottom. Then open
the safety catch by sliding the flap to the side. The thermometer is powered by two LR44 batteries. Make sure that the flap is
closed correctly before using it again.
NOTE: The electronic thermometer is not waterproof. Do not lead to flooding. Only the probe should be placed in water.
07. CLEANING
1. Clean the tub with a soft, damp cloth using mild soap. Do not use strong detergents for cleaning. Wipe dry before storing so
that no water marks are visible.
2. Clean the bath liner by hand with a mild soap. Do not use strong detergents for cleaning. Then squeeze out excess water and
hang upright to dry. Do not dry-clean. Do not use bleach. Do not iron.
08. TRANSPORT
Remember to transport the tub only with the legs folded down. Transporting the product unfolded may cause damage.
09. SPECIFICATIONS:
Bath material: PP + TPE
8