Publicidad
EN
WARNING:
Remember not to use it while driving to avoid
unnecessary trouble.
Inflation Instructions
Using a DC12V or AC electric pump to inflate the car air mattress: open
the air nozzle cover, plug the DC 12V or AC electric pump into the
power supply, connect the medium nozzle to the electric pump cover,
insert the nozzle into the air inlet of the bed, and turn on the power
switch to inflate. The saturation of the inflation must be controlled at
about 95%. Then turn off the power switch to stop inflation, remove the
electric pump, and just cover the air nozzle cover for using.
Deflation, Folding and Storage:
1. Open the air nozzle cover on the side of the air bed to make naturally
deflated. If you need to deflate more quickly, you can fold or squeeze
the air mattress.
2. Press and release the remaining air in the mattress when folding for
multiple times.
3. Put the bed into a carrying case and store it in a clean and dry place
for the next time use.
4. Regular maintenance and cleaning of the car air mattress.
WARNING:
1. Do not get close to sharp objects during use and place them on a flat
surface.
2. Do not get close to flammable objects or sources of ignition.
3. Do not use on water or near water.
4. Please do not jump on the bed, which may cause personal injury or
damage to the bed.
5. Please do not use the air mattress in a very cold place. Please inflate
the air mattress at a normal temperature. PVC materials will become
hard and brittle in cold conditions and easily get damaged. Do not
use any heating equipment or hair dryer because it will cause
damage to the air mattress.
6. If the car air mattress is dirty, just clean it with a damp cloth and do
not use any chemicals.
06
Patching Instructions:
Needle eye repair
1. After the air mattress is deflated, cover the nozzle and reduce the gas
flow in the mattress.
2. Take out the glue in the repair kit and add a drop of glue to the needle
eye to complete the repair. Wait for four hours before refilling.
3. If the needle eye is large, take a toothpick, apply the glue on the tip of
the toothpick, apply it to the damaged area and fill the needle eye
with glue.
4. After the repair is completed, wait for four hours before refilling.
Repair scratches and burns
1. After the air mattress is deflated, cover the nozzle and reduce the gas
flow in the air mattress.
2. Find the patch material in the repair kit and cut a piece that needs to
fully cover the broken seam.
3. Apply the glue to the damaged area, press the patch, and glue the
edges of the patch.
4. Apply pressure to ensure there are no gaps on the rubber surface
and press it with smooth, heavy objects.
5. Wait for eight hours before inflating and repair is completed.
Flocking surface repair
1. Carefully clean the repair area.
2. After drying, remove the patch, cut it and cover it over the damaged
surface to allow the patch to be a little more than the surrounding
leather.
3. Apply a layer of glue to the patch and the damaged surface, and glue
the edges of the patch to ensure a complete seal.
4. squeeze it with a smooth, heavy object.
5. Press it with heavy objects for 24 hours, then inflate and the repair is
completed.
07
Publicidad
