Publicidad
Idiomas disponibles
Idiomas disponibles
3. STORAGE AND MAINTENANCE
When not in use,the filter should be stored in a dry place within the temperature range of -20°C to +70°C Prolonged
exposure at temperature above 45°C ma y decrease the battery lifetime of the filter.It is recommended to keep the solar
cells of the filter in the dark or not exposed to light during storage in order to maintain power down mode.This can be
achieved by simply placing the filter face down on the storage shelf.
Warning:
Protection cover Lens ,both internal and external (Polycarbonate) must be used in conjunction with the
autodarkening filter in order to protect it against permanent damage.
It is always necessary to keep the solar cells and the light sensors of the filter free of dust and spatters: cleaning can be
done with a soft tissue or a cloth soaked in mild detergent (or alcohol).Never use aggressive solvents such as acetone.
If protection screens are in any way damaged,they must be immediately replaced.
Replacing External Cover Lens:
remove/replace the external cover lens.
Replacing Internal Cover Lens:
until it releases from edges of the cartridge of view window.
Change the Shade Cartridge:
holder to allow filter cartridge to be removed from the frame. Install new filter cartridge into frame(See Fig.2). Make sure
that the filter cartridge is inserted in filter holder correctly as shown and install filter holder assembly into helmet shell.
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Remove filter holder by moving locks toward center (Fig.1) and lift up the filter holder to
Place your fingernail in recess below the cartridge of view window and flex lens upwards
Remove filter holder assembly from helmet shell (See Fig.1). Then flex top end of the filter
Fig1
02
C S v M
7 6 0
Fig2
Publicidad
