RCA RSWL1 Guia De Instalacion página 10

E. Place the leak sensor on the floor beneath the washer shutoff valves.
Agua detectada
F. Plug in the smart module.
1. Plug the smart module's power adapter into the jack on the side of the smart module.
IMPORTANT: If you're using the laundry shut-off system without the smart module, plug the power adapter directly into
the DC In jack on the control unit.
2. Plug the other end of the power adapter into an available power outlet.
If both power outlets are in use (by the washer and dryer, for example), use the included 3-outlet power wall tap to
provide additional outlets.
When the smart module and control unit first power on, the yellow indicator light on the front panel of the control unit
flashes—the auto shut off valve system is arming and opening valves. When the green indicator light comes on, the
system is ready to use.
10
Make sure the sensor is sitting flat on the floor directly beneath the shutoff valves.
(Do not place it inside the washer floor tray if you have one.)