Publicidad
Idiomas disponibles
Idiomas disponibles
,
For storage, wipe the hexshaft
and
sprockets
with 5W30 motor oil
NOTE: Clean all excess grease or
oll found on the rubber friction
wheel or the disc drive plate.
CAUTION:
Do not allow grease or
oil to contact the rubber friction
wheel or the disc drive plate,
6.
Install the bottom panel.
Chain
13
AUGER
GEAR BOX
The auger gear box is lubricated at the
factory and should not require addition-
al lubrication.
If for some reason the
lubricant should leak out, have auger
gear case checked by a competent
re-
pairman.
ENGINE
LUBRICATION
Check the crankcase oil level before
starting the engine and after each five
(5) hours of continuous
use. See
Figure 14. Add S.A.E. 5W30 motor oil
as needed.
Tighten fill cap/dipstick
se-
curely
each time you check the oil lev-
el.
Oil Fill Cap/
D
Figure 14
Change the oil every twenty-five
(25)
hours or at least once a year if the
snow thrower is not used for twenty-
five (25) hours.
TO CHANGE
ENGINE OIL
1. Position the snow thrower so that
the oil drain plug is at the lowest
point on the engine.
2.
Remove the oil drain plug and the
oil fill cap/dipstick.
Drain the oil
into a suitable container.
.
4.
NOTE: The oil will drain more freely
when the engine is warm.
After draining all the oil, reinstall the
oil drain plug securely.
Fill the engine crankcase with
S.A.E. 5W30 motor oil, pouring
slowly. DO NOT OVERFILL.
See
'qo Add Oil" in the Operation Sec-
tion.
SPARK PLUG
Check the spark plug every twenty-
five (25) hours. Replace the spark plug
if the electrodes are pitted or burned or
if the porcelain is cracked.
1. Make sure the spark plug is clean.
Clean the spark plug by carefully
scraping the electrodes (do not
sand blast or use a wire brush).
2. Check the spark plug gap with a
feeler gauge and reset gap to 0.30"
if necessary. See Figure 15.
.
Before installing the spark plug,
coat the threads lightly with oil for
easy removal. 13ghten the spark
plug to a torque of 15 foot-pounds.
Feeler Gauge
Spark Plug
Figure 15
17
Publicidad
