Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
OF PARTS BAG (ACTUAL
SIZE)
1 - Owner's
Manual
(not shown)
1 - Packet
of Fuel Stabilizer
(not shown)
1 - Warranty Card (not shown)
*Non-Assembly
Parts, found in toolbox located on belt cover
PARTS PACKED SEPERATELY
IN CARTON
(NOT SHOWN FULL SIZE)
2- Ignition Keys
(attached to engine in plastic bag)
d_lb
WARNING:
Always wear
safety glasses or eye shields
while assembling
snow
thrower.
TOOLS REQUIRED
FOR
ASSEMBLY
1 - Knife to cut carton
2 - 1/2 inch wrenches
(or adjustable wrenches)
2 - 9/16 inch wrenches
(or adjustable wrenches)
2 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
Figure 1
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References
to the right or left hand side
of the snow thrower are from the view-
point of the operator's
position behind
the unit.
6
Publicidad
