Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
Drum/Caddy
Assembly
If any parts are missing or damaged
contact your Sears Store or Sears
Service Center.
Do not assemble until you have all the
parts.
1. Remove left and right caddies from
drum.
2. Install cap nut on one side of shaft rod.
Tap gently with rubber mallet or
hammer until fully seated. Slide open
end of shaft through the wheel (smooth
side of wheel facing outward).
3. Place wheel/shaft
assembly through
caddy left and on through the caddy
right, as shown.
4. Then place the remaining wheel onto
the caddy assembly (smooth side of
wheel facing outward), and install
second cap nut.
5. Invert drum to install caddy. Place the
caddy assembly onto the drum, as
shown. Be sure that wheels spin freely,
and do not contact the caddies.
6. Once the caddies are aligned on the
drum, gently tap each end of each
caddy until firmly seated. It is
recommended
to tap the center portion
of the front caddies, as shown.
7. Using a rubber mallet or hammer,
gently tap the wheel caps onto each
wheel until the wheel caps are firmly
seated onto each wheel. This is
required on both sides.
NOTE: Smooth side of
-
Sho!t
R°d Caddy_/4_
_
Wheel
Right
_,,-, y/_-r._
,/Cap
CADDY
_
[j
_-_
Nut
ASSEMBLY
_
TAP
y
/
Wheel Cap
Mallet
¢
Publicidad
