MikroTik L009UiGS-2HaxD-IN Guía Rápida página 6

•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be
used with the unit to ensure compliance.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the
authorized antennas in the USA (or where FCC rules apply); only those antennas certified with the
product are to be used. The installer should configure the output power level of antennas, according
to country regulations and per antenna type. Professional installation is required for equipment
with connectors to ensure compliance with health and safety issues.
APPROVED 2.4 GHz ANTENNA:
•
3.46 dBi Omnidirectional Antenna (Model: HGO indoor antenna).
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC
radiation exposure limits set forth for an uncontrolled environment. This MikroTik device should
be installed and operated no closer than 20 centimeters from your body, occupational user, or the
general public.
Innovation, Science and Economic Development Canada
Model
L009UiGS-2HaxD-IN 7442A-L0092AXIN
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science, and Economic Development Canada's license-exempt RSS(s). Operation is subject to the
following two conditions: (1) This device may not cause interference. (2) This device must accept
any interference, including interference that may cause undesired operation of the device.
CAN ICES-003 (B) / NMB-003 (B)
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential
for harmful interference to co-channel mobile satellite systems.
IC ID