Publicidad
Idiomas disponibles
Idiomas disponibles
ANGLE GRINDER
4.
Closely inspect the Grinding or Cut-Off Wheel before
mounting. Perform a ring-test on the wheel (unless
wheel is smaller than 4" or is an unusual shape) as
follows:
a. Suspend wheel using a dowel or nger through the
arbor hole.
b. Tap the at side of the wheel with a light non-metallic
object, such as a screwdriver handle, at a point 45º
from the vertical center line on each side of the wheel
and 1-2 inches from the edge of the wheel (see
illustration).
c. Rotate the wheel 90º and repeat the test until the
entire wheel has been checked.
d. An undamaged wheel will give a clear tone. If cracked,
there will be a dead sound and not a clear ring.
5.
For wheels with paper gaskets (blotters) or metal gaskets:
Slip the wheel onto the Spindle with the gasket rst. The
gasket should be centered on the wheel and the wheel and
gasket should rest at against the Flange.
WARNING
To prevent serious injury, gaskets must be used for all
grinding wheels they are provided with. Gaskets help
prevent grinding wheel damage and wheel slippage,
causes of wheel failure.
6.
Thread the Flange Nut onto the Spindle. Wrench tighten
only enough so that the wheel is securely held on the
spindle.
WARNING
To prevent serious injury, do not overtighten Flange Nut.
Overtightening can damage the wheel, causing wheel
failure.
INSTALLING A THREADED ACCESSORY
WARNING
TO PREVENT INJURY: Wear heavy duty work gloves when
handling wire wheels and brushes. These accessories are
sharp and can cause injury. Do not exceed maximum
rated speed of brush. Do not use damaged brush. Replace
damaged brushes immediately. Damaged or worn brushes
will forcefully shoot wires into all objects not covered by
the guard.
1.
The accessory MUST be:
•
rated to at least 11,000 RPM
•
no larger than 5" in diameter
•
fitted with a threaded opening of 5/8" x 11 TPI
•
undamaged
•
a sanding disc and backing pad, a sanding flap disc, a
wire wheel or a wire cup brush (accessories not
included)
2.
Press in and hold the Spindle Lock Button to prevent the
Spindle from turning.
3.
Remove the Flange Nut and the Flange and keep in a safe
place.
4.
Thread disc accessory rmly onto the Spindle. Wrench
tighten onto the Spindle.
WORKPIECE AND WORK AREA SET UP
1.
Designate a work area that is clean and well lit. The work
area must not allow access by children or pets to prevent
distraction and injury.
2.
Route the power cord along a safe route to reach the work
area without creating a tripping hazard or exposing the
power cord to possible damage. The power cord must
reach the work area with enough extra length to allow
free movement while working.
3.
Secure loose workpieces using a vise or clamps (not
included) to prevent movement while working.
4.
There must not be hazardous objects, such as utility lines
or foreign objects, nearby that will present a hazard while
working.
5.
You must use personal safety equipment including, but
not limited to, ANSI-approved eye and hearing protection,
as well as heavy duty work gloves.
6.
Before beginning work, provide for sparks and debris that
will y off the work surface.
11
INSTALLATION
Publicidad
