Lincoln Electric K5447-1 Manual De Instrucciones página 16

ANGLE GRINDER
OPERATION
WARNING
TO PREVENT SERIOUS INJURY:
1. Make sure that the Paddle Switch is not locked on, then plug
in the tool.
2. To turn the tool ON, push the Paddle Switch safety latch
backward while depressing the Paddle Switch.
To engage the Paddle Switch lock, turn the tool ON and
press the switch lock in - this will keep the tool ON until the
Paddle Switch is depressed releasing the lock.
3. Allow the tool to come up to full speed before touching the
work material.
For grinding or sanding operations, apply the wheel or
disc to the work material at a 10º - 15º angle, allowing the
tool to operate at full speed. If the tool bogs down, use
lighter pressure. To create a smoother surface, keep the
tool moving over the work surface.
For abrasive cutting-off operations, apply the cut-off
wheel straight into the work material using only the edge of
the wheel, allowing the tool to operate at full speed. If the
tool bogs down, use lighter pressure.
WARNING
DO NOT GRIND WITH THE SIDE OF THE CUT-OFF
WHEEL.
Abrasive cut-off wheels are intended for peripheral
grinding; side forces applied to these wheels may cause
them to shatter.
NOTICE
TO PREVENT TOOL DAMAGE:
Only use the tool for 15-20 minutes at a time. Allow the
tool to cool completely before next use.
4. When nished, release the Paddle Switch to stop the
tool.
TO PREVENT ACCIDENTS, AFTER USE:
5.
Turn off the tool.
WARNING
ALLOW THE TOOL TO COME TO A COMPLETE STOP
BEFORE SETTING IT DOWN.
Unplug the tool. Clean, then store the tool indoors out of
them to shatter.
12
OPERATION