Publicidad
Idiomas disponibles
Idiomas disponibles
The operation
of any tractor
can
result in foreign objects
thrown into the
eyes, which can result in severe eye damage.
Always
wear safety glasses
or eye shields
while operating
your tractor or performing
any adjustments
or repairs.
We recommend
standard
safety glasses
or a wide vision safety
mask worn over spectacles.
HOW
TO
USE YOUR
TRACTOR
TO SET PARKING
BRAKE
Your tractor
is equipped
with an operator
presence
sensing
switch,
When engine is
running, any attempt by the operator to leave
the seat without first setting the parking brake
will shut off the engine.
1. Depress
brake pedal (B) allthe way down
and hold.
2. Pull parking brake lever (C) up and hold,
release
pressure
from brake pedal (B),
then release parking
brake lever.
Pedal
should
remain
in brake position.
Make
sure parking brake will hold tractor secure.
STOPPING
MOWER
BLADES
-
- To stop mower blades,
move attachment
clutch clutch lever to disengaged
position
(r_t)
Attachment
Clutch Switch
"Engaged"
(t_'t)Attachment
Clutch Switch
"Disengaged"
GROUND
DRIVE
-
- To stop ground drive, depress brake pedal
all the way down_
IMPORTANT:
Forward
and reverse
drive
pedals
return
to neutral
position
when
not
depressed.
ENGINE
-
• Move throttle control (D) between half and
full speed
(fast) position.
NOTE:
Failure to move throttle
control be-
tween half and full speed (fast) position, be-
fore stopping,
may cause engine to "backfire".
• Turn ignition
key (F) to "STOP"
position
and remove key. Always remove keywhen
leaving tractorto prevent unauthorized
use.
, Never use choke
(N) to stop engine°
IMPORTANT:
Leaving
the ignition switch in
any position
other than "STOP"
will cause
the battery
to discharge
and go dead.
NOTE:
Undercertain
conditionswhen
tractor
is standing
idle with the engine running,
hot
engine
exhaust
gases
may cause "brown-
ing" of grass.
To eliminate
this possibility,
always
stop engine
when
stopping
tractor
on grass areas°
CAUTION:
Always
stop tractor
com-
pletely, as described
above, before leaving
the operator's
position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast).
° Operating engine at less than full speed
(fast)reducesengine'soperatingefficiency.
• Full speed (fast) offers the best mower
performance.
TO USE CHOKE
CONTROL
(N)
Use choke control whenever
you are starting
a cold engine_ Do not use to start a warm
engine.
° To engage
choke
control,
pull knob out.
Slowly push knob in to disengage°
15
Publicidad
