Publicidad
Idiomas disponibles
Idiomas disponibles
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the forward and reverse drive
pedals.
1. Start tractor
and release
parking
brake_
2. Slowly depressforward(K) or reverse(L)
drive pedal to begin movement, Ground
speed increases the further down the
pedal is depressed.
TO USE CRUISE
CONTROL
The cruise control feature
can be used for
forward
travel only.
SYSTEM
CHARACTERISTICS
The cruise
control
should
only
be used
while mowing or transporting on relatively
smooth,
straight surfaces.
Other conditions
such as trimming at slow speeds may cause
the cruise control to disengage.
Do not use
the cruise control on slopes,
rough terrian
or while trimmimg or turning.
• With forward
drive
pedal depressed
to
desired
speed,
pull cruise control
lever
(J) up and hold while lifting your foot off
the pedal, then release
the lever°
To disengage
the cruise control, depress the
brake pedal, tap on forward
drive pedal or
push the cruise control
lever down.
TO ADJUST
MOWER
CUTTING
HEIGHT
The position
of the attachment
lift lever (A)
determines
the cutting
height.
• Put attachment
lift lever in desired cutting
height slot.
° Slide
pointer
tab (T) to desired
cutting
height as a reminder for next time you mow.
The cutting
height
range is approximately
I" to 4". The heights are measured
from the
ground to the blade tip with the engine not run-
ning.These
heights are approximate
and may
vary depending
upon soil conditions,
height
of grass and types of grass being mowed.
• The average
lawn should
be cut to ap-
proximately
2-1/2" during the cool season
and to over 3" during
hot months.
For
healthier
and better looking
lawns,
mow
often and after moderate
growth,
, For best cutting performance,
grass over
6" in height should be mowed twice. Make
the first cut relatively
high; the second
to
desired
heighL
TO ADJUST
GAUGE
WHEELS
Gauge wheels
are properly
adjusted
when
they are slightly off the ground when mower
is at the desired
cutting
height in operating
position.
Gauge wheels then keep the deck
in proper position
to help prevent
scalping
in most terrain
conditions°
NOTE; Adjust gauge wheels with tractor on
a flat level surface.
1. Adjust
mower
to desired
cutting
height
(See "TO ADJUST
MOWER
CUTTING
HEIGHT"
in this section
of manual).
2. With mower in desired height of cut posi-
tion, gaugewheels
should be assembled
so they are slightly off the ground.
Install
gauge wheel in appropriate
hole. Tighten
securely.
3_ Repeat for all, installing
gauge wheel in
same adjustment
hole.
TO OPERATE
MOWER
Your tractor is equipped
with an operator
presence sensing switch. Any attempt by the
operator
to leave the seat with the engine
running and the attachment
clutch engaged
will shut off the engine.
You must remain
fully and centrally
positioned
in the seat to
prevent the engine from hesitating
or cutting
offwhen
operating
your equipment
on rough,
rolling terrain or hilts.
I.
Select desired
height of cut with attach-
ment lift lever.
2_ Start mower blades by engaging
attach-
ment clutch control.
16
Publicidad
