Publicidad
Idiomas disponibles
Idiomas disponibles
Refer to Figure
1.
Check
for shipping
damage.
If damage
has occurred,
a
claim
must be filed with carrier.
Check for completeness.
immediately
report
missing
parts
to dealer.
The planer
comes
assembled
as one unit. Additional
parts
which
need to be fastened
to planer
should
be located
and
accounted
for before
assembling.
A. Handle
Assembly
with
Bolt and Plug
B. Dust Chute with
Screw
C. Digital
Display
Buttons
and LCD Covers
D. Half Bag Dust Collection
Set
B
Figure 1 - Unpacking Planer
WARNING:
Do not attempt
assembly
if parts
are missing.
Use this manual
to order
replacement
parts.
Figure 3 - Install Batteries
INSTALL COVERS AND BUTTONS ON THE
DIGITAL DISPLAY
•
Using
a needle
or pin, carefully
lift and remove
the
protective
film on the LCD (see Figure
4).
•
Place
a cover on each LCD.
•
Insert
the buttons
firmly
in position.
NOTE:
The square
button
is placed
in position
'A'.
Cover
Button
INSTALL
BATTERIES
•
Loosen and remove four socket head pan screws and
then remove the display panel cover (see Figure 2).
Film on
LCD
Figure 4 - Install Covers and Buttons on Digital
Display
Figure 2 - Remove Display Panel
•
Insert
four (4) C batteries
(not included).
Make
sure to
install the batteries
using the correct
polarity
(i.e., the "+"
symbol
on the battery
aligns
with the "+" symbol
on the
battery
holder).
•
Replace
the cover and secure
in position
with the four
socket
head
pan screws.
INSTALL
HANDLE
Refer to Figure 5.
•
Handle
with knob is installed
on the top right of the planer.
•
Insert
handle
with knob onto elevation
screw top.
•
Secure
handle
with socket head
bolt using wrench
provided.
•
Insert
plug into handle
to cover
bolt.
Plug
Figure 5 - Installing Handle
Publicidad
