Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL
DUST
CHUTE
Refer to Figure
6.
•
Slide
dust chute
over fan housing.
Secure
in position
with
screw.
•
Attach
the Half Bag Dust Collection
Set (included)
only
after mounting
planer
to stand
or workbench.
Figure 6 - Installing Dust Chute
MOUNT PLANER TO STAND
Refer to Figure
7.
CAUTION:
Planer
weighs
approximately
100 Ibs. Two people
may be required
to lift planer.
*
Planer
is designed
to be portable
so it can be moved
to
job site, but should
be mounted
to a stand or workbench
for stability.
*
Make sure
stand
is located
on a firm,
level surface
in a
place with ample
lighting
and correct
power supply.
*
Make
sure there
is plenty
of room for moving
the work-
piece through
the entire
cut. There
must be enough
room
that neither
the operators
or bystanders
will have to stand
in line with the wood while
using the tool.
.
The base of the planer
has four mounting
holes, two in
front
(shown
in Figure
7) and two in the rear.
Figure 7 - Planer Mounting
Holes (Front)
•
Mount
planer
to workbench
or tool stand
(see Recom-
mended
Accessories,
page
17) using bolts, fiat washers
and hex nuts (not supplied).
•
Figure
8 shows
the base dimensions
and mounting
hole
dimensions
of the planer.
3/e"
Dia.
113/8"
15"
25W'
Figure 8 - Base and Mounting
Dimensions
-7
15"
INSTALL
THE
HALF
BAG
DUST
COLLECTION
SET
Refer to Figure
9.
The Craftsman
Half Bag Dust Collection
Set is designed
to provide
dust collection
for woodworking
tools with a 2W'
diameter
dust exhaust
port. The filter
bag attaches
to a
30-gallon
trash
can or a 30-gallon
x 1.3 mil plastic
trash
bag for easy, convenient
sawdust
disposal
(trash
can and
plastic
trash
bag not included).
•
Mount
planer
to stand
before
installing
Dust Collection
Set.
To use dust collection
set with a trash
can:
•
Place
spring
inside
filter
bag arm.
•
Slide
arm with spring
over dust chute.
•
Place
band
of the bag over rim of trash
can and secure
bag by tightening
strap.
To use dust collection
set with a trash
bag:
•
Place
spring
inside
filter
bag arm.
•
Slide
arm with spring
over dust chute.
•
Assemble
bag support.
Slide connectors
into channels
of
support
segments.
•
Slide
plastic trash
bag inside
and over bag support.
Let
bag overlap
3-4".
•
Place
band
of the filter bag over and into the channel
of
the bag support.
•
Secure
in position
by tightening
strap.
Spring
......... -_
Dust Chute
Support
Segments
Connector
_k_ __
Bag
P
_O
_
Support
Trash
Bag
Figure 9 - Half Bag Dust Collection
Set
4
Publicidad
