Publicidad
Idiomas disponibles
Idiomas disponibles
.,___ Gearbox
_
Dust Cup
Trimmer Head
_
Retainh_g
Washer
4.
Remove the screwdriver.
ATTACHING
THE PLASTIC
SHIELD
_
WARNING:
The shield must be
properly
installed. The shield provides
partial protection
from the risk of
thrown objects to the operator
and oth-
ers and is equipped with a line limiter
blade which cuts excess line to the
proper length. The line limiter blade
(on underside
of shield) is sharp and
can cut you.
1.
Remove wing nut from shield.
2.
Insert bracket into slot on shield.
3.
Pivot shield until bolt passes
through hole in bracket.
4.
Tighten the wing nut securely.
Slot Bracket
_:_
Shield
Wing Nut
\
clockwise. Remove the screwdriver.
To remove the plastic shield, loosen and
remove wing nut. Pivot shield to release
bracket from slot. See INSTALLATIONOF
THE TRIMMER HEAD and Alq-ACHING
THE PLASTIC SHIELD for illustrations.
Be
sure to store all parts and instructions for
future use. Never use the trimmer head
with the metal blade installed.
ATTACHING
THE METAL SHIELD
,4(_,WARNING:
The metal shield
must be properly installed on the tool
anytime the tool is used with a blade.
The forward tip of the metal shield
helps to reduce the occurrence
of
blade thrust which can cause serious
injury such as amputation
to the opera-
tor or bystanders.
Failure to install the
shield in the position shown can result
in serious
injury to the operator. The
length of the shield must be aligned
with the length of the shaft.
1.
Place the metal shield under the
gearbox, and align the screw holes.
_ Gearbox
Shiek
\
Gearbox
ASSEMBLY
INFORMATION
- WEED
BLADE
_'
WEED
BLADE
NOTE:
Remove the trimmer head and
plastic shield before attaching the metal
shield and installing the weed blade. To
remove the trimmer head, align hole in
the dust cup with the hole in the side of
the gearbox by rotating the dust cup.
Insert a small screwdriver into aligned
holes. This will keep the shaft from turn-
ing while loosening the trimmer head.
Remove the trimmer head by turning
2.
Insert and thread the 4 mounting
screws through the holes of the
gearbox
and the metal shield.
Tighten evenly and securely with
the hex wrench provided.
INSTALLATION
OF THE METAL
BLADE
WARNING:
Wear protective
gloves when handling or performing
maintenance
on the blade to avoid in-
jury. The blade is sharp and can cut
you even when it is not moving.
_WARNING:
Do not use any
blades, or fastening hardware other than
the washers and nuts shown in the fol-
lowing illustrations. These parts must be
provided by Sears and installed as
shown below. Failure to use proper parts
can cause the blade to fly off and seri-
ously hurt you or others.
8
Publicidad
